16 Terminals 3V~6.5V 16-Pin SI9140 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 20kHz~2MHz Transistor Driver

With a 16-TSSOP (0.173, 4.40mm Width) package, the switching controller is suitable for a wide range of applications. For 1 outputs, the dc motor controller is appropriate. A solid enclosure of Tape & Reel (TR) surrounds pmic. Transistor Driver dc switching's outputs (s) can be handled by it. This dc control has a supply voltage and operating voltage of 3V~6.5V. Worked in an dc switcher with a -40°C~85°C TA rating. Switching can be done at 20kHz~2MHz with this switching controller. The Surface Mount value makes it suitable for general dc dc regulator. For efficient switching control, the dcdc regulator features Enable, Frequency Control. A SWITCHING CONTROLLER analog IC is connected to the switch converters. The switching converters's terminals (s) are designed at DUAL. An array of 16 terminations of dc switching. These dc dc converter ics adapt a variety of control techniques, including PULSE WIDTH MODULATION. The nominal DC switcher's voltage input is 5V. Search for "SI9140" to find other relevant dc to dc converter ics. There are a total of 16 pins on switching converter. It is recommended that the input voltage of the dc dc voltage regulator be 3V. At most, the dc to dc regulator accepts 6.5V input voltage. You should note that the dc dc regulator's usual output current is 380mA. In most applications and prototypes, DC switcher's Surface Mount makes it suitable. DC regulator has a maximum frequency of 2MHz. To better satisfy the need, DC to DC voltage regulator has a value of IT ALSO OPERATES IN CURRENT MODE.