16 Terminals 10V~16.5V 16-Pin SI9118 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 40kHz~1MHz Transistor Driver

In the 16-SOIC (0.154, 3.90mm Width) package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 1. There is a Bulk solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 10V~16.5V volts and has 10V~16.5V supply voltage. Suitable for working in an dc switcher that has a -40°C~85°C TA. It can switch at 40kHz~1MHz. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Current Limit, Enable, Frequency Control, Soft Start is included in the dcdc regulator. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. Various 16 terminations. This dc dc converter ic uses a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 10V. In addition to "SI9118", there are other relevant dc to dc converter ics you can find. There are 16 pins on switching converter. DC regulator outputs 11.5V voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is 500mA. Voltage regulator dc to dc is designed to operate at 80 % duty cycle during power-ups and power-downs to ensure reliability. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. DC regulator1MHz has the maximum frequency. In order for the voltage regulator dc to dc to perform safely and reliably in a circuit, users are advised to apply 16.5V. 3mA volts is the supply current.