2 Channels 500nA Instrumentational OP Amps 0.5μA 20 Pins LCC

Packaged in a LCC case, the buffer op amp is ready to use. An op amp ic of the COMPARATOR type. There is a growing number of terminations approaching the number of 20. The pins on this board total to 20 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 20 pins are present on the instrumentation amplifier. There is an input offset voltage of 3.8mV for this buffer op amp. 92.04dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs OPEN-COLLECTOR signals. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. For packing the buffer amplifier, the TUBE-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 36V. A high supply voltage of more than 5V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts.