75ns, 50ns SPST - NC 60Ohm DUAL Analog Switches BREAK-BEFORE-MAKE DG9262 8 Pins 100pA 3V 8-SOIC (0.154, 3.90mm Width)

Shipping overseas is convenient with the electronic component packed in 8-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 8. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. An electrical component like this is included in the 8 series. A SPST - NC switching circuit is used to build these analog multiplexers. Try searching with DG9262 if you're looking for variants. There is 60Ohm internal resistance in this digital multiplexer. For functions related to 8 pins, please refer to the datasheets. A voltage higher than 12V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. 2.7V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 1μA current would be sufficient. This analog switch requires a voltage of 2.7V~12V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. It is possible to operate 2 inputs.