5V 1.27mm PMIC ATF2500C(L) Series ATF2500 44 Pin 71MHz 5V 44-CLCC (J-Lead)

24 macrocells are present in the mobile phone network, which offer radio coverage from a high-power cell tower, antenna, or mast.The item is enclosed in a 44-CLCC (J-Lead) package.The device is programmed with 24 I/O ports.It is programmed to terminate devices at 44.There is a QUAD terminal position on the electrical part in question.The device is powered by a voltage of 5V volts.It is recommended that the chip be packaged by Tube.Ensure its reliability by operating at -55°C~125°C TC.It is recommended to mount the chip by Surface Mount.FPGAs belonging to the ATF2500C(L) series contain this type of chip.With 44 pins programmed, the chip is ready to use.When using this device, NO is also available.You can find its related parts in the ATF2500.2500 gates are used to construct digital circuits.If high efficiency is desired, the supply voltage should be kept at 5V.It is recommended that data be stored in EEPROM.In this case, it is mounted by Surface Mount.The pins are 44.This device operates at a voltage of 5.5V when the maximum supply voltage is applied.With a minimal supply voltage of 4.5V, it operates.A power supply of 5V volts is required to operate this device.Currently, there are 24 Programmable I/Os available.This frequency is 71MHz.It is important to make sure that the maximum frequency is less than 71 MHz.It is recommended that the operating temperature be higher than -55 °C.It is recommended that the operating temperature be below 125 °C.The status of input signals is determined by 13 dedicated inputs.In programmable logic, a type of logic can be categorized as EE PLD.Operating temperatures should not exceed 125C.It is recommended that the operating temperature be as low as -55C.