0.5mm PMIC 10 Pin 1.5MHz 3.6V
1.5MHz is the frequency in which it operates.There are 10 terminations that are designed to operate with it.The configuration of the board is built around 10 pins.Segments counted are 14.6V is a maximum acceptable voltage for the supply.A voltage of 27V is produced by it.There are 10 pins on it.A minimal input voltage of 3V is required for it to operate.A minimum supply voltage of 2.5V is required to meet the highest efficiency standards.6V is the maximum value of the supply current.It is capable of delivering high efficiency when the maximal supply current is below 2mA.For stable operation, the operating temperature should not exceed 85°C.For stable operation, the operating temperature should be higher than -40°C.At maximum output current 35mA, it will deliver all the benefits of a LED driver.There is no external factor that consumes current when there is 2mA current consumption.In this part, LED DISPLAY DRIVER represents the interface IC.Voltages above 27V should not be allowed.The interface IC that the part is equipped with is indicated by 45mA.2.5V is the minimal voltage it outputs.Currently, there are 2 channels available for transmission.