0.5mm PMIC TPS61141 10 Pin 1.2MHz 10-VFDFN Exposed Pad
10-VFDFN Exposed Pad saves board space. As part of the design of this LED driver, there are 2 outputs that have been used.In order to mount the led light driver, Surface Mount is used.When it emerges as a DC DC Regulator, it shows high-performance and reliability.LED drivers capable of operating at -40°C~85°C TA can be used.Backlight has many advantages.The system operates on the basis of the frequency 1.2MHz.In this case, it operates with terminations of 0.In this LED driver, the base is configured as 10.The number of segments is estimated to be 4.LED drivers have a base part number of TPS61141.There is no problem with the voltage of 6V.10 pins are used on the device.The minimal input voltage is 3V.In order to achieve the highest efficiency, it is designed to operate at a low voltage of 2.5V.Whenever the maximum supply current is allowed, the value reaches 6V.Whenever the supply current is lower than 2mA, it can provide high efficiency.Loads can only be powered by 23mA current.When operating with a maximum output current of 23mA, it can deliver all the benefits of a LED driver.When no external factors are present, there is 125μA current consumption.It is important to keep the output voltage below 27V.A circuit operated by the device has 3.6V volts.It maintains a 2.5V minimum voltage output.A further characteristic of this LED driver is that it is PFM TECHNIQUE IS ALSO POSSIBLE.