Enable Adjustable 1.702 mm MIC29502 PMIC -- Series 5 TO-263-6, D2Pak (5 Leads + Tab), TO-263BA
A Tube case is used to deliver this IC regulator. This voltage regulator IC comes in a TO-263-6, D2Pak (5 Leads + Tab), TO-263BA case. Output type Adjustable. This component features 1 Voltage regulators. As a result of the Linear Voltage Regulator's design, the operating temperature of Surface Mount can be adjusted within a specified range. There is a temperature range of -40°C~125°C degrees during operation of the IC regulator. There is a configuration in this voltage regulator IC that specifies that its output function is Positive. In terms of its current output, it is able to supply 5A. A total of 5 pins can be found on the board. In order to deliver prompt, sufficient and reliable performance, this regulator IC has 1 outputs in total. A dropout voltage of 10 volts can be obtained from this voltage regulator IC. There are 5 pins on the chip. As an FYI, this IC voltage regulator has the basic part number MIC29502. An example of such a component would be this PMIC - Power Management ICs component. This device is regulated with the Low Dropout Voltage type of regulator. Taking into account the operation requirements, the maximum output current of the IC voltage regulator reaches 5A. It operates in the 50mA Quiescent Current state. This model is a part of the -- Series and is of high quality. If the temperature is below 125°C, it is recommended that you utilize this feature. It is recommended that the chip be operated at a temperature no lower than -40°C operating temperature. The top supply voltage can be set to 26V volts. 1 % tolerance is what this regulator IC has, which is quite low. Each of these 1 channels performs a specific task to keep the system functioning.