Tape & Reel (TR) Obsolete 1 Surface Mount Hot Swap Controllers 4mA mA Auto Retry 14-SOIC (0.154, 3.90mm Width) 1 -48V Hot Swap Controller, Sequencer

In the 14-SOIC (0.154, 3.90mm Width) package you will find it.Channel 1 is currently available.A Tape & Reel (TR)-shaped package holds it.Device DUAL is located at the terminal position.As Surface Mount would say, it's set up like that.The electrical component in question falls into the classification Hot Swap Controller, Sequencer.A reliable operation requires the temperature to be set to -40°C~85°C.Apps for -48V are available on the device.A feature of Auto Retry describes it.Using a -80V~-19VV power source should be able to power the device.The MIC2589 family includes it.During operation, 14 pins are used.Hot-swappable device has Current Limit, Fault Timeout, OVP, UVLO programmable features.Presently, there is a sufficient supply of 4mA.As you can see, it is positioned in the direction of Surface Mount.For stable operation, the maximum operating temperature should be 85°C°C.At a minimum working temperature of -40°C degrees Celsius, it maintains its reliability.Hot-swappable device is recommended to keep the supply voltage (Vsup) above 19 V so that the device can function normally.Vsup is set to 80 V, the maximum supply voltage.As you can see in this example, the gadget uses an analog IC called POWER SUPPLY SUPPORT CIRCUIT.Hot Swap is set by default to output 1.An input voltage of -80VV is the maximum it can handle.Device --V has a maximum output.Using a low supply voltage, such as -19VV, will be feasible.Hot Swap is 4mA which is the operative supply current.There is an electrical component in this series called --.