Tape & Reel (TR) Active 1 Surface Mount Hot Swap Controllers 2mA mA Latched Fault 8-SOIC (0.154, 3.90mm Width) 1 General Purpose Hot Swap Controller

As part of the 8-SOIC (0.154, 3.90mm Width) package, it is included.1 channels are currently available.The package looks like a Tape & Reel (TR).Its terminal position is DUAL.In total, it has 8 pins.Surface Mount is set up this way.Electrical components classified as Hot Swap Controller are referred to as Hot Swap Controller components.To ensure reliable operation, the temperature should be set to -40°C~85°C.There are General Purpose applications on the device.The article appears in Latched Fault.Hot-swappable device should work if you use a 10V~80VV power source.MIC2587 is a family of numbers.A 8 pin is used for operation.PMIC - Power Management ICs contains this gadget all by itself.There are Current Limit, Fault Timeout, Slew Rate, UVLO programmable features on this device.This is the current supply of 2mA.The position of the object is in the direction of Surface Mount.For stable operation, 85°C°C is the maximum operating temperature.For reliability, it must work at a minimum temperature of -40°C degrees Celsius.For normal operation, Vsup should be kept above 10 V.Hot-swappable device is set to 80 V (maximum supply voltage).An analog IC, in this case POWER SUPPLY SUPPORT CIRCUIT, is used in this gadget.80VV is the maximum supply voltage it can handle.--V is the device's maximum output.With a 10VV supply voltage, it can work as low as possible.Supply current 2mA is operative.-- series components are used in this electrical component.