Tape & Reel (TR) Active 1 Surface Mount Hot Swap Controllers 1.5mA mA Auto Retry 16-SSOP (0.154, 3.90mm Width) 1 General Purpose Hot Swap Controller
You can find it in the 16-SSOP (0.154, 3.90mm Width) package.At the moment, 1 channels are accessible.In the form of a Tape & Reel (TR), it is packaged.In this case, the device is located at terminal DUAL.The device has a total of 16 pins.Surface Mount has set it up this way.An electrical component classified as Hot Swap Controller belongs to this category.Ensure reliable operation by setting the temperature to -40°C~85°C.A General Purpose application is available for the device.There is a mention of it in Auto Retry.In theory, it should work as long as the power source has a 2.3V~13.2VV input.This number is a member of the MIC2583 family.In order to operate, 16 pins are used.A gadget like this is self-contained in PMIC - Power Management ICs.The programmable features of this device are Fault Timeout, Slew Rate, UVLO.Presently, there is a limited supply of 1.5mA.In Surface Mount direction, it is positioned.Hot-swappable device is possible to maintain stable operation at a maximum temperature of 85°C°C.At a minimum working temperature of -40°C degrees Celsius, it maintains reliability.Normally, Vsup should remain above 2.3 V.The maximum supply voltage is set to 13.2 V.As the name suggests, this gadget uses an analog IC, which in this case is POWER SUPPLY MANAGEMENT CIRCUIT.A maximum voltage of 13.2VV can be supplied to it.Its maximum output is --V.If necessary, it can work with a low supply voltage, such as 2.3VV.Currently, 1.5mA is the supply current.Its maximum current requirement is 2.5mA.Using this device, you can also produce UNDERVOLTAGE LOCKOUT PROTECTION, POWER ON RESET.-- series components make up this electrical component.