Tape & Reel (TR) Active 1 Surface Mount Hot Swap Controllers 1.5mA mA Latched Fault 16-SSOP (0.154, 3.90mm Width) 1 General Purpose Hot Swap Controller
The 16-SSOP (0.154, 3.90mm Width) package contains it.Hot-swappable device is currently possible to access 1 channels.There is a Tape & Reel (TR)-shaped package for it.This device has a terminal position of DUAL.16 pins make up its total.Surface Mount sets it up.This electrical component belongs to the Hot Swap Controller classification.Hot-swappable device is recommended that the temperature is set to -40°C~85°C in order to ensure reliable performance.Devices with General Purpose applications are available.In Latched Fault, it is featured.As long as you have a 2.3V~13.2VV power source, it should work.MIC2583 numbers belong to this family.16 pins are used to operate the system.The gadget in PMIC - Power Management ICs is self-contained.Fault Timeout, Slew Rate, UVLO is the number of features it can be programmed with.Currently, 1.5mA is in short supply.Surface Mount is its direction of movement.Hot-swappable device is stable to operate at a temperature of 85°C°C at the maximum.Hot-swappable device works at a minimum temperature of -40°C degrees Celsius to maintain reliabilHot-swappable devicey.In order for a device to operate normally, the supply voltage (Vsup) must be higher than 2.3 V.There is a value of 13.2 V set for Vsup (maximum supply voltage).There is a POWER SUPPLY MANAGEMENT CIRCUIT IC in this gadget, which is an analog IC.Maximum supply voltage is 13.2VV.In terms of output, the device has a maximum of -V.Low supply voltages, such as 2.3VV, can be used.Its operative supply current is 1.5mA.2.5mA is the maximum current required for its operation.The same device can also be used to produce UNDERVOLTAGE LOCKOUT PROTECTION, POWER ON RESET.There are several electrical components in the - series, including this one.