Tape & Reel (TR) Active 1 Surface Mount Hot Swap Controllers 1.5mA mA Latched Fault 8-SOIC (0.154, 3.90mm Width) 1 General Purpose Hot Swap Controller

This is included in the 8-SOIC (0.154, 3.90mm Width) package.At present, 1 channels are available.It's packaged in a Tape & Reel (TR) shape.Device position DUAL is its terminal position.In total, there are 8 pins on it.According to Surface Mount, it has been set up.Electric components of this type are classified as Hot Swap Controller.For reliable operation, set the temperature to -40°C~85°C.Application General Purpose is available on the device.As you can see in Latched Fault, it's featured.The device should be able to be powered by a 2.3V~13.2VV power source.There are numbers in the MIC2582 family that include it.8 pins are used in operation.As far as PMIC - Power Management ICs is concerned, this gadget is self-contained.There are Slew Rate, UVLO features that can be programmed.In the present, there is a shortage of 1.5mA.Positioned in direction of Surface Mount, it is at a right angle.Operating at 85°C°C ensures stable performance.The system must function at a minimum temperature of -40°C degrees Celsius in order to maintain its reliability.Hot-swappable device is important that the supply voltage (Vsup) is kept above 2.3 V for normal operation of the device.13.2 V (maximum supply voltage) is set.As for the IC, this gadget uses POWER SUPPLY MANAGEMENT CIRCUIT.In default mode, it outputs 1.An output voltage of 13.2VV is its maximum.The device produces --V as its maximum output.Hot Swap works wHot Swaph as low a voltage as possible, such as 2.3VV.There is a supply current of 1.5mA.Hot Swap requires 2.5mA volts of current to operate.By using this device, it is also possible to produce UNDERVOLTAGE LOCKOUT PROTECTION, POWER ON RESET.There is a -- series component on this electrical component.