4.5V~32V 12-Pin MIC2198 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 500kHz Transistor Driver
In the 12-VFDFN Exposed Pad, 12-MLF® package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 1. There is a Tape & Reel (TR) solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 4.5V~32V volts and has 4.5V~32V supply voltage. Suitable for working in an dc switcher that has a -40°C~125°C TJ. It can switch at 500kHz. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Enable is included in the dcdc regulator. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. This dc dc converter ic uses a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 12 V. In addition to "MIC2198", there are other relevant dc to dc converter ics you can find. There are 12 pins on switching converter. Specifically, switching converter falls under the PMIC - Power Management ICs category. DC regulator outputs 800mV voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is 20A. Voltage regulator dc to dc is designed to operate at 76 % duty cycle during power-ups and power-downs to ensure reliability. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. Hence, ALSO OPERATES IN ADJUSTABLE MODE FROM 0.8 TO 6 V is used to better suit the DC to DC voltage regulator's situation. In order for the voltage regulator dc to dc to perform safely and reliably in a circuit, users are advised to apply 4.5, 32 V. You should keep dc regulator at -40°C degrees or higher. There should be 125°C temperature above 125°C degrees Celsius when dc regulator runs. The dc to dc voltage regulator is from the -- series. 1 functions (s) are included in the switch converters. Designing voltage regulators switchings with 12 pins. There would be 12-MLF™ (4x4) supplier dc dc controller package for this part. During switching, this controller has a phase of 1. It is possible for this switching controller to switch at a frequency of 550 kHz. Voltage rating is 32V. The frequency at which this controller can perform well is 500 kHz.