2.9V~14V 16-Pin MIC2185 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 400kHz Transistor Driver

In the 16-SSOP (0.154, 3.90mm Width) package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 1. There is a Tube solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 2.9V~14V volts and has 2.9V~14V supply voltage. Suitable for working in an dc switcher that has a -40°C~85°C TA. It can switch at 400kHz. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Enable, Frequency Control, Soft Start is included in the dcdc regulator. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. This dc dc converter ic uses a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 5 V. In addition to "MIC2185", there are other relevant dc to dc converter ics you can find. There are 16 pins on switching converter. Specifically, switching converter falls under the PMIC - Power Management ICs category. DC regulator outputs Adjustable voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is -. Voltage regulator dc to dc is designed to operate at 85 % duty cycle during power-ups and power-downs to ensure reliability. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. DC regulator440kHz has the maximum frequency. A frequency of 440kHz is set for the switching controller. You should keep dc regulator at -40°C degrees or higher. There should be 125°C temperature above 125°C degrees Celsius when dc regulator runs. The dc to dc voltage regulator is from the -- series. 1 functions (s) are included in the switch converters. There would be 16-QSOP supplier dc dc controller package for this part. 3.8mA volts is the supply current. It is possible for this switching controller to switch at a frequency of 440 kHz. Voltage rating is 14V. The frequency at which this controller can perform well is 200 kHz, 400 kHz.