4.5V~32V 16-Pin MIC2182 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 300kHz Transistor Driver
This switching controller fits most application requirements since it is packaged in a 16-SSOP (0.209, 5.30mm Width) package. 1 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tape & Reel (TR). Transistor Driver dc switching's outputs (s) are supported. 4.5V~32V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~85°C TA dc switcher. There is a switch at 300kHz that can be used with this controller. dc dc regulator is made easier with Surface Mount. Enable, Soft Start is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at DUAL . It includes PULSE WIDTH MODULATION as one of the control techniques dc dc converter ic adapts. DC switcher's input voltageis set to 15 V. You can find other relevant dc to dc converter ics by searching "MIC2182". There are only 16 pins on switching converter. In particular, switching converter belongs to the PMIC - Power Management ICs family. DC regulator outputs 6V voltage according to the test statistics. normally, the dc dc regulator's output current is 20mA, which you should keep in mind when starting a project. voltage regulator dc to dcs with a 86 % duty cycle are designed to be reliable when powered on and powered off. Having a Surface Mount makes DC switcher ideal for most prototype and application designs. The value of DC to DC voltage regulator is set to ALSO OPERATES IN ADJUSTABLE MODE FROM 1.25 TO 6 V in order to better satisfy the requirement. In order to run the voltage regulator dc to dc safely and reliably, users are advised to apply 2.9, 14 V. A temperature of -40°C or higher is recommended. A temperature of 85°C degrees Celsius is recommended. Thare are switch converters of the -- series. A total of 1 functions are present in the switch converters. When the dc switching is dormant, it uses 600μA. It is planned to design voltage regulators switchings with 16 pins. It would be 16-SSOP for this part's supplier dc dc controller package. Output current will not exceed 20A. Switches with 1 phases are used in this controller. The top frequency at which this switching controller can switch is 330 kHz. As far as maximum supply voltage is concerned, switching voltage regulators is rated as 32V.