4.5V~75V 10-Pin MIC2176 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 300kHz Transistor Driver

Capsuled in the 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) package, the switching controller can be used for a wide range of applications. There is enough capacity in the dc motor controller to generate the output for the 1 input. PMIC packaging is solid with a Tube enclosure. A total of Transistor Driver dc switching's outputs can be handled by it. Voltages 4.5V~75V are the dc control's supply voltage and operating voltage, respectively. Work well in dc switchers with a -40°C~125°C TJ. Using this switching controller, it is possible to switch at 300kHz. A generalization of dc dc regulator can be made using Surface Mount. To ensure efficient switching, this dcdc regulator features a Enable. An analog IC with the SWITCHING CONTROLLER signal is connected to the switch converters. A switching converters's terminal (s) sits at the DUAL position. DC switcher's voltage input is 48 V. You can find other relevant dc to dc converter ics by searching "MIC2176". Pins number 10 of switching converter in total. Specially, switching converter corresponds to type PMIC - Power Management ICs. Test statistics indicate DC regulator outputs 800mV voltage. In most cases, the dc dc regulator's output current is 15A. This information should be noted when you begin working with the component. As a result of this, the maximum duty cycle of the voltage regulator dc to dc must remain 89 % during power-up and power-down. The Surface Mount makes DC switcher suitable for most applications and prototypes. It is estimated that this dc regulatorhas a maximum frequency of 375kHz. The value of DC to DC voltage regulator is set at ALSO OPERATES IN ADJUSTABLE MODE DOWN TO 0.8 V in order to fulfill the requirements more effectively. Users should apply 3, 14.5 V to operate the voltage regulator dc to dc safely and reliably. At least -40°C°C is recommended. At125°C, dc regulator should run. Basically, it's a dc to dc voltage regulator from the Hyper Speed Control® series. 1 functions are available in total for the switch converters. We design voltage regulators switchings with 10 pins. A 10-MSOP would be the supplier dc dc controller package for this part. There will be 15A current output from the dc switcher above 15A. The phase of this controller is 1. In this switching controller, 375 kHz represents the top frequency at which it can switch. Voltage maximum is rated 75V. At 100 kHz, this controller will mostly work as expected.