3V~14.5V 10-Pin MIC2169 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 500kHz Transistor Driver
This switching controller fits most application requirements since it is packaged in a 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) package. 1 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tape & Reel (TR). Transistor Driver dc switching's outputs (s) are supported. 3V~14.5V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~125°C TJ dc switcher. There is a switch at 500kHz that can be used with this controller. dc dc regulator is made easier with Surface Mount. Current Limit is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at DUAL . It includes PULSE WIDTH MODULATION as one of the control techniques dc dc converter ic adapts. DC switcher's input voltageis set to 5 V. You can find other relevant dc to dc converter ics by searching "MIC2169". There are only 10 pins on switching converter. In particular, switching converter belongs to the PMIC - Power Management ICs family. DC regulator outputs 800mV voltage according to the test statistics. voltage regulator dc to dcs with a 92 % duty cycle are designed to be reliable when powered on and powered off. Having a Surface Mount makes DC switcher ideal for most prototype and application designs. DC regulator's maximum frequency is 550kHz. Switching controllers operate at 550kHz frequencies. The value of DC to DC voltage regulator is set to ALSO HAS OUTPUT VOLTAGE ADJUSTABLE DOWN TO 0.8V in order to better satisfy the requirement. A temperature of -40°C or higher is recommended. A temperature of 125°C degrees Celsius is recommended. Thare are switch converters of the -- series. A total of 1 functions are present in the switch converters. It is planned to design voltage regulators switchings with 10 pins. Users must limit the voltage accordingly because the dc switcher's maximum input voltage is 14.5V. It would be 10-MSOP for this part's supplier dc dc controller package. The supply voltage must be 3V. A supply current of 3 mA is used to power it. Switches with 1 phases are used in this controller. The top frequency at which this switching controller can switch is 550 kHz. As far as maximum supply voltage is concerned, switching voltage regulators is rated as 14.5V. There is 3mA nominal current supply for this the controllers dc. This controller performs best at a frequency of 500 kHz.