3V~28V 10-Pin MIC2164 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 300kHz Transistor Driver

This switching controller fits most application requirements since it is packaged in a 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) package. 1 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tape & Reel (TR). Transistor Driver dc switching's outputs (s) are supported. 3V~28V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~125°C TJ dc switcher. There is a switch at 300kHz that can be used with this controller. dc dc regulator is made easier with Surface Mount. Enable is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at DUAL . It includes HYSTERETIC CURRENT MODE as one of the control techniques dc dc converter ic adapts. DC switcher's input voltageis set to 5 V. You can find other relevant dc to dc converter ics by searching "MIC2164". There are only 10 pins on switching converter. In particular, switching converter belongs to the PMIC - Power Management ICs family. DC regulator outputs 5.5V voltage according to the test statistics. normally, the dc dc regulator's output current is 25A, which you should keep in mind when starting a project. voltage regulator dc to dcs with a 87 % duty cycle are designed to be reliable when powered on and powered off. Having a Surface Mount makes DC switcher ideal for most prototype and application designs. DC regulator's maximum frequency is 375kHz. The value of DC to DC voltage regulator is set to ALSO OPERATES IN ADJUSTABLE MODE FROM 0.8 TO 5.5V in order to better satisfy the requirement. In order to run the voltage regulator dc to dc safely and reliably, users are advised to apply 28V. A temperature of -40°C or higher is recommended. A temperature of 125°C degrees Celsius is recommended. Thare are switch converters of the Hyper Speed Control® series. A total of 1 functions are present in the switch converters. It is planned to design voltage regulators switchings with 10 pins. It would be 10-MSOP for this part's supplier dc dc controller package. Switches with 1 phases are used in this controller. The top frequency at which this switching controller can switch is 375 kHz. If the current exceeds 3A, the component may not operate correctly and may even be damaged.