3V~28V MIC2164 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 600kHz Transistor Driver

As a result of 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) compact design, the switching controller is compatible with most applications. 1 outputs are supported by the dc motor controller. An enclosure of Tape & Reel (TR) is used to package the PMIC. The system can process Transistor Driver dc switching's outputs (s). 3V~28V is the supply voltage and the operating voltage of the dc control. Workable in an dc switcher where -40°C~125°C TJ is the -40°C~125°C TJrm. The switching controller is capable of switching at the 600kHz position. dc dc regulator can be generalized using Surface Mount. Switching control is made easier with the dcdc regulator's Enable. Connected to a SWITCHING CONTROLLER analog IC, the switch converters are connected to a power supply. switching converters terminal (s) are designed to be at DUAL. Some of the control techniques used by these dc dc converter ics are HYSTERETIC CURRENT MODE. It is inputted with a DC switcher's voltage of 5 V. A search for "MIC2164" will reveal other relevant dc to dc converter ics. The type is a particular PMIC - Power Management ICs of switching converter. The maximum duty cycle of this voltage regulator dc to dc is set to 74 % to ensure reliability during power-up and power-down. DC regulators have a maximum frequency of 750kHz. DC to DC voltage regulator has the value of ALSO OPERATES IN ADJUSTABLE MODE FROM 0.8 TO 5.5V to better satisfy the requirement. A circuit should contain 14.5V in order to ensure the voltage regulator dc to dc runs safely and reliably. A temperature -40°C lower than -40°C should be maintained. A temperature of 125°C more than 125°C degrees Celsius should be maintained in the undc regulator. There are several dc to dc voltage regulator in the Hyper Speed Control® series. In total, thare switch converters have 1 functions. A voltage regulators switching with 10 pins is designed. Supplier dc dc controller package for this part is 10-MSOP. With this controller, the phase is 1. This controller can operate at a frequency up to 750 kHz. There is a possibility that a current higher than 10mA will cause improper operation of the component and possibly damage switching voltage regulators.