4.5V~75V 16-Pin MIC2103 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 200kHz~600kHz Transistor Driver

Capsuled in the 16-VFQFN Exposed Pad package, the switching controller can be used for a wide range of applications. There is enough capacity in the dc motor controller to generate the output for the 1 input. PMIC packaging is solid with a Cut Tape (CT) enclosure. A total of Transistor Driver dc switching's outputs can be handled by it. Voltages 4.5V~75V are the dc control's supply voltage and operating voltage, respectively. Work well in dc switchers with a -40°C~125°C TJ. Using this switching controller, it is possible to switch at 200kHz~600kHz. A generalization of dc dc regulator can be made using Surface Mount. To ensure efficient switching, this dcdc regulator features a Current Limit, Enable, Frequency Control, Power Good. An analog IC with the SWITCHING CONTROLLER signal is connected to the switch converters. A switching converters's terminal (s) sits at the QUAD position. DC switcher's voltage input is 48 V. You can find other relevant dc to dc converter ics by searching "MIC2103". Pins number 16 of switching converter in total. Specially, switching converter corresponds to type PMIC - Power Management ICs. Test statistics indicate DC regulator outputs 800 mV to 24 V voltage. In most cases, the dc dc regulator's output current is 15A. This information should be noted when you begin working with the component. As a result of this, the maximum duty cycle of the voltage regulator dc to dc must remain 85 % during power-up and power-down. The Surface Mount makes DC switcher suitable for most applications and prototypes. The value of DC to DC voltage regulator is set at ADJUSTABLE OUTPUT VOLTAGE RANGE FROM 0.8 V TO 24 V in order to fulfill the requirements more effectively. Users should apply 8, 40 V to operate the voltage regulator dc to dc safely and reliably. At least -40°C°C is recommended. At125°C, dc regulator should run. Basically, it's a dc to dc voltage regulator from the HyperLight Load® series. 1 functions are available in total for the switch converters. We design voltage regulators switchings with 16 pins. A 16-MLF® (3x3) would be the supplier dc dc controller package for this part. The phase of this controller is 1. In this switching controller, 750 kHz represents the top frequency at which it can switch. Voltage maximum is rated 75V. At 200 kHz to 600 kHz, this controller will mostly work as expected.