P-Channel 0.95 mm PMIC -- Series MIC2005 6 Pin SOT-23-6
It is packaged in the form of a Tape & Reel (TR).It is included with the SOT-23-6 package as well.A Surface Mount mounting is used for the LED driving board.The switch type of this switch is General Purpose.To ensure reliable performance, the temperature should be set to -40°C~85°C TA.The lighting driver has a total of 1 outputs that are available for use.With a supply voltage of Not Required, the LED driving board operates.A maximum output voltage of P-Channel volts can be obtained with this LED driver.There are Slew Rate Controlled features available on the LED driving board.As you can see, it comes from the MIC2005 family.During operation, the 6 pins are used.It is important to note that the LED driving board has 1 functions.From the lighting driver, there is a maximum output of 500mAV.To comply with the operation criteria, the maximum output current is reduced to 500mA.Surface Mount is mounted in the way of this LED driving board.This LED driver is equipped with a total of 6 pins.In this case, there is 70mOhm resistance in the LED driving board.It is included in the -- series.This results in a 2 A output current.The LED driver is packaged in an econtainer with a capacity of Switch ICs.The maximum supply voltage for this lighting driver is set to 5.5 V (Vsup).In order to operate normally, the supply voltage (Vsup) must remain above 2.5 V.This LED driving board uses an analog IC POWER SUPPLY SUPPORT CIRCUIT.A total of 1 channels are available for you to choose from.For maximum efficiency, the supply voltage should be set to 2.5 V to 5.5 V.The maximum input voltage of the LED driver is 5.5V volts.There is a minimum input voltage of 2.5V volts for this LED driver.It is designed to be stable at 85°C°C, which is the maximum operating temperature.The LED driver must work at a minimum temperature of -40°C degrees Celsius in order to remain reliable.It can handle a maximum voltage of 5.5VV.It can also be used at 2.5Vvolts if needed.In this case, the electrical component is classified as High Side Switch/USB Power Distribution Switch.