Enable, Power Good Fixed 1.7 mm MCP1825 PMIC -- Series 3 TO-220-5

The package is delivered in a Tube case. In order to package the IC voltage regulator, a TO-220-5 case is used. On the Voltage regulator IC, there are 5 terminations that can be connected. This IC Regulator has a type of output called Fixed. There are 1 regulators implemented in this electroic component. Through Hole can be adjusted in the Linear IC in order to vary the temperature range over which Linear Regulator operates. The IC voltage regulator must be maintained at -40°C~125°C degrees for it to function. As you can see, this regulator's output function is configured to be Positive. At present, it can produce an output of up to 500mA. As you can see, the regulator IC has a total of 3 pins. The regulator has a total of 1 outputs to make sure that it delivers prompt, sufficient outputs. A dropout voltage of 10 volts is what makes it a dropout voltage. Depending on the chip, 5 pins may be available. For your information, part number MCP1825 is the basic part number for this voltage regulator IC. As far as the regulator type, it is a FIXED POSITIVE SINGLE OUTPUT LDO REGULATOR type. There is a maximum output current of 500mA for this regulator to meet the operational requirements. It operates in the 220μA Quiescent Current state. The -- Series is a series of products made by D-Link. As a general rule, it is recommended that you use the IC voltage regulator when temperatures are below 125 °C degrees Celsius. At the lowest operating temperature that can be reached by the chip, it is -40 °C. There are 1 channels in this voltage regulator IC that perform different tasks to keep the system running.