24 Terminals 4V~36V 24-Pin LTC3862 DC to DC converter IC DUAL SWITCHING CONTROLLER 2 Outputs 75kHz~500kHz Transistor Driver

In the 24-WQFN Exposed Pad package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 2. There is a Tube solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 4V~36V volts and has 4V~36V supply voltage. Suitable for working in an dc switcher that has a -40°C~150°C TJ. It can switch at 75kHz~500kHz. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Enable, Frequency Control, Phase Control, Soft Start is included in the dcdc regulator. A DUAL SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. QUAD are the position of the terminal of the switching converters. Various 24 terminations. This dc dc converter ic uses a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 12V. In addition to "LTC3862", there are other relevant dc to dc converter ics you can find. There are 24 pins on switching converter. DC regulator outputs 200V voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is 50mA. A frequency of 500kHz is set for the switching controller. Since the dc switcher's maximum input voltage is 36V, the voltage must be regulated accordingly. An output current greater than 50mA cannot be provided by the dc switcher. Depending on the datasheet, the switching converter can output 5.2V volts at its peak. A voltage controller's lowest output voltage cannot be less than 4.8V. Communication on 1 channels is high-quality.