38 Terminals 4.5V~38V 38-Pin LTC3856 DC to DC converter IC SWITCHING CONTROLLER 2 Outputs 250kHz~770kHz Transistor Driver

This switching controller fits most application requirements since it is packaged in a 38-TFSOP (0.173, 4.40mm Width) Exposed Pad package. 2 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tape & Reel (TR). Transistor Driver dc switching's outputs (s) are supported. 4.5V~38V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~125°C TJ dc switcher. There is a switch at 250kHz~770kHz that can be used with this controller. dc dc regulator is made easier with Surface Mount. Current Limit, Enable, Frequency Control, Phase Control, Power Good, Soft Start, Tracking is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at DUAL . A variety of terminations with 38 of dc switching. DC switcher's input voltageis set to 15V. You can find other relevant dc to dc converter ics by searching "LTC3856". There are only 38 pins on switching converter. DC regulator outputs 5V voltage according to the test statistics. normally, the dc dc regulator's output current is 25A, which you should keep in mind when starting a project. DC regulator's maximum frequency is 850kHz. The value of DC to DC voltage regulator is set to ALSO OPERATES AS LDO REGULATOR, OPERATES IN ADJUSTABLE MODE FROM 0.6 TO 5V in order to better satisfy the requirement. Thare are switch converters of the PolyPhase® series. A high-quality communication requires 1 channels.