28 Terminals 4.5V~38V 28-Pin LTC3787 DC to DC converter IC SWITCHING CONTROLLER 2 Outputs 105kHz~760kHz Transistor Driver

This switching controller fits most application requirements since it is packaged in a 28-SSOP (0.154, 3.90mm Width) package. 2 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tube. Transistor Driver dc switching's outputs (s) are supported. 4.5V~38V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~125°C TJ dc switcher. There is a switch at 105kHz~760kHz that can be used with this controller. dc dc regulator is made easier with Surface Mount. Current Limit, Enable, Frequency Control, Power Good, Soft Start is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at DUAL . A variety of terminations with 28 of dc switching. It includes PULSE WIDTH MODULATION as one of the control techniques dc dc converter ic adapts. DC switcher's input voltageis set to 12V. You can find other relevant dc to dc converter ics by searching "LTC3787". There are only 28 pins on switching converter. dc dc voltage regulators should have a minimum input voltage of 4.5V. DC regulator outputs 60V voltage according to the test statistics. The dc to dc regulator can only accept a maximum input voltage of 38V. normally, the dc dc regulator's output current is 20A, which you should keep in mind when starting a project. DC regulator's maximum frequency is 850kHz. The value of DC to DC voltage regulator is set to ALSO HAS OUTPUT VOLTAGE UP TO 60V in order to better satisfy the requirement. Thare are switch converters of the PolyPhase® series. A high-quality communication requires 1 channels.