28 Terminals 4V~30V 28-Pin LTC3727 DC to DC converter IC SWITCHING CONTROLLER 2 Outputs 255kHz~530kHz Transistor Driver

It comes in a 28-SSOP (0.209, 5.30mm Width) package, so switching controller can be used for most applications. This dc motor controller can be used to generate outputs with 2 numbers. Tape & Reel (TR) is the solid enclosure in which PMIC is packaged. With Transistor Driver dc switching's output (s), it is able to handle it. dc controls with 4V~30V voltage are supplied and operated. A -40°C~85°C TA dc switcher is not a problem. A switching controller such as this can switch at a value of 255kHz~530kHz . It is suitable for general dc dc regulator when it is set to Surface Mount. DCDC regulator is controlled efficiently by Enable, Power Good, Soft Start. Switch converters are connected to ICs with SWITCHING CONTROLLER analog outputs. Thare switching converters has a terminal (s) at DUAL . A variety of 28 terminations are available in dc switching. These dc dc converter ics adapt several control methods, including PULSE WIDTH MODULATION. DC switcher's input voltageis 15V volts. LTC3727 can be used to locate other relevant dc to dc converter ics. The switching converter has a total of 28 pins. 4V should be the minimum input voltage for the dc dc voltage regulator. As determined by the test statistics, the output voltage of DC regulator is 14V. The dc to dc regulator is limited to 36V input voltage. This dc regulatorhas a max frequency of 580kHz. The output value is set to the greatest value of 3A. Communication with high quality requires 1 channels.