LMV654MT Overview
Packaged in a TSSOP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 3V battery. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.5mV for this buffer op amp. 94dB should remain the voltage gain. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 125°C should be used. The operating supply voltage of the buffer op amp is rated at 5V. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 5.5V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. A total of 4 instrumentation amplifiers are present on the device.
LMV654MT Features
14 Pins
supply voltage of 3V
94dB voltage gain
LMV654MT Applications
There are a lot of Texas Instruments
LMV654MT Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection