LM7171AMJ-QML Overview
It is packaged in an CDIP-case that protects the operational amplifiers from damage. An op amp of this type is a OPERATIONAL AMPLIFIER-type. It is estimated that there will be at least 8 terminations this year. A total of 8 pins are attached to buffer op amp. As a reminder, this buffer op amp should be powered by 5V battery and that the battery should be inserted in the amplifier. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. In total, the buffer amplifier consists of 8 pins. Op amp ic rates 4mV for input offset voltage. There should be no change in the voltage gain at 75dB. There are a total of 1 channels available on the op amps. This instrumentation amplifier cannot operate below -55°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 125°C. The operating supply voltage of the buffer op amp is rated at 18V. An buffer amplifier is packed in a TUBE-shape according to the design. It is important to keep in mind that the power supply voltage of this electric component is below 36V, which is suitable. Keeping the linear amplifier's supply voltage above 5.5V is recommended. In order to conduct this part, you will need to provide dual supply voltages of 18V volts.
LM7171AMJ-QML Features
8 Pins
supply voltage of 5V
75dB voltage gain
LM7171AMJ-QML Applications
There are a lot of Texas Instruments
LM7171AMJ-QML Instrumentational OP Amps applications.
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering