1 Channels 100nA Instrumentational OP Amps 8 Pins CDIP

In the package, you will find a CDIP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the COMPARATOR-type. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 15V battery. The op amp ic has an array of 8 pins on it. Op amp rates 3mV as input offset voltage. You should keep the voltage gain at 106.02dB for the time being. On the buffer amps, there are 1 channels that can be used. Buffer amplifier produces OPEN-COLLECTOR signals, which is one of its many benefits. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. The linear amplifier is packaged by using a TUBE axis. This electric component can work from a voltage of under 36V as far as supply voltage is concerned. A voltage of 5V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 18V volts when you conduct this part.