51ns, 35ns SPST - NO/NC 3Ohm Analog Switches BREAK-BEFORE-MAKE DG9426 1nA 16-TSSOP (0.173, 4.40mm Width)

As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 16. Circuits based on SPST - NO/NC switching are used to construct these analog switch ics. Try searching with DG9426 to find analog multiplexer variants. An switch multiplexer with 3Ohm internal resistance has a value of 3Ohm. Datasheets for 16 pin functions are available upon request. Multiplexers should not be powered above 12V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2.7V. An operating current of 5μA would be sufficient for this switch device. When the digital multiplexer is charged above 1μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 6V. It is recommended that you attach at least 3V to your dual power supply. An analog IC with the number DPDT is integrated into this board. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Operating the 4 inputs requires 4 inputs.