140ns, 80ns SPST - NC 9Ohm Analog Switches BREAK-BEFORE-MAKE DG467 6 Pins 1nA 15V SOT-23-6 Thin, TSOT-23-6

The electrical component comes in SOT-23-6 Thin, TSOT-23-6 packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 6 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 6 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Circuits number 1 make up this analogue multiplexer. Look for analog switch ic variants by searching with DG467. A 9Ohm internal resistance characterizes this multiplexer. The datasheets for the 6 pins explain the functions. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 7V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 20μA current. A voltage higher than 15μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 20VFor dual power supplies, a voltage of at least 4.5V should be attached. Among the inputs that can be operated are the 2 inputs. There is 7Ohm Drain to Source resistance on this electronic part.