300ns, 250ns SPDT 50Ohm DUAL Analog Switches BREAK-BEFORE-MAKE 5nA 15V 14-CDIP (0.300, 7.62mm)

Shipping overseas is convenient with the electronic component packed in 14-CDIP (0.300, 7.62mm). High reliability is provided by advanced packaging method Tube. In Through Hole, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:1. Temperatures around -55°C~125°C TA are extended for operation. Total terminations are 14. If the voltage supply is 15V volts, the electrical component should be turned on and run. A SPDT switching circuit is used to build these analog multiplexers. There are 1 circuits in this multiplexer. There is 50Ohm internal resistance in this digital multiplexer. For functions related to 14 pins, please refer to the datasheets. A voltage higher than 36V should not normally be supplied to the switches. 10V should be the lowest voltage fed to the electronic component. The analogue multiplexer may be damaged if voltage is greater than 500μA. If put voltage greater than 18V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 5V. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. 28V operating voltages are supported by the electronic component.