30ns, 28ns SPST - NC 800mOhm DUAL Analog Switches BREAK-BEFORE-MAKE DG2742 8 Pins 1nA 1.8V 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) Exposed Pad
The electrical component comes in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) Exposed Pad packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 8 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 1.8V, it should be turned on and run. Into the electrical component body are injected 8 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Look for analog switch ic variants by searching with DG2742. A 8Ohm internal resistance characterizes this multiplexer. The datasheets for the 8 pins explain the functions. An abnormal situation would be for the switch device to be supplied with a voltage greater than 3.6V. A analog switch ic that has a cost-effective Single supply type. It is recommended to use 1.5V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 10nA current. Analogue multiplexers require a 1.5V~3.6V voltage to drain from a single voltage supply. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. Among the inputs that can be operated are the 2 inputs. You shouldn't miss the additional features of the electrical component, such as: VIDEO APPLICATION.